Mobotix T24S Informations techniques télécharger pdf (Page 26)

26/98

T24 System Manual Part 2: System Startup Without A PC

www.mobotix.com • [email protected]

2.1.3 Start Auto-Conﬁguration

The light and bell buttons on the camera module begin to light up white while rebooting.

Within four seconds of the buttons lighting up on reboot, press the doorbell button on

the camera module (lower button) until the two buttons start to ﬂash brieﬂy.

This Starts The Auto-Conﬁguration Process And The Following Happens:

• The lights on the camera module start to ﬂash as the T24 starts up.

• The current T24 IP address and network data are announced automatically.

• Each Grandstream videophone is contacted and conﬁgured by the T24.

•

Each Grandstream videophone is restarted automatically each time the conﬁguration

is updated.

• Each Grandstream videophone displays its newly assigned IP address (for example,

192.168.0.20) and SIP quick dial number (for example, MX_SIP *101) on the display.

• The SIP quick dial number for the ﬁrst videophone is *101 and the T24 uses *201.

The auto-conﬁguration process is complete when the camera LEDs light up, all the keypad*

number buttons start to ﬂash, the ESC/ALARM button ﬂashes red and the OK/MENU button

ﬂashes blue.

Press the bell button

immediately after

the buttons light up

* if present in

the system

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 99 100

Pas de commentaire

Mobotix T24S Informations techniques Page 26