Mobotix T24S Informations techniques télécharger pdf (Page 84)

100

84/98

T24 System Manual Part 2: System Restore

www.mobotix.com • [email protected]

A special system restore procedure is required after exchanging modules. It is described

in 5.2.1– 5.2.6 below.

5.2.1 Exchanging Keypad– With System Restore

You need to disconnect the door station’s power supply

before exchanging the keypad. To restore the system after

exchanging it, you will need an up-to-date backup of the

system conﬁguration.

Proceed As Follows:

1. Disconnect the door station from the power supply (for

example, remove the network plug).

2. Remove the keypad to be exchanged from the module frame as described in the

T24 System Manual Part 1/Section 2.4.6 (Removing And Exchanging Modules).

Exchange the keypads. Take care not to damage the cabling or mix up the connections.

The connection diagrams are provided in the T24 System Manual Part 1.

4. Reconnect the power supply, wait until the system has booted and run a system

restore via the video phone, as described in 5.2. The door station is now ready

for operation and can once again be used with the PINs and transponder cards

set up for your system.

5.2.2 Exchanging Security Door Opener– With System Restore

You need to disconnect the door station’s power supply before

exchanging the security door opener. To restore the system

after exchanging it, you will need an up-to-date backup of

the system conﬁguration.

Proceed As Follows:

Disconnect the door station from the power supply (for example, remove the network

plug).

2. Exchange the security door openers. Take care not to damage the cabling or mix

up the connections. The connection diagrams are provided in the T24 System

Manual Part 1.

3. Reconnect the power supply, wait until the system has booted and run a system

restore via the video phone, as described in 5.1. The door station is now ready

for operation and can once again be used with the PINs and transponder cards

set up for your system.

Contact your MOBOTIX

Support team to

exchange (used) keypads

and security door

openers that no longer

have factory default

condition (the devices

will need to undergo

a hardware reset)

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Mobotix T24S Informations techniques Page 84

Commentaires sur ces manuels